Bosch Sensixx DS37 Gebrauchsanleitung Seite 21

Problem Possible causes
The appliance • Water is being pumped into the
makes a pumping steam tank.
sound. • The water tank is not fitted onto
the housing correctly.
• The sound will not stop.
Loss of pressure • Steam release button has been
during ironing. activated for too long a period of
time, that is, it has been pressed
too frequently.
Water spots appear • May be caused by steam
on the garment condensed on the ironing board.
during ironing.
Water spots appear • Water spots are caused by
on the garment steam condensation in the hose
during use of the when cooling down after use.
"PulseSteam"
function.
The hose gets hot • This is normal. It is caused by
during use. the steam passing through the
hose during steam ironing.
Water leakage from • Drainage plug located at the
the boiler. bottom of the appliance is loose.
The iron does not stop • "PulseSteam" function has been
steaming after placing activated by double click.
it on the pad (2).
If the above does not solve the problem, get in touch with our customer service.
You can download this manual from the local homepages of Bosch.
Solution
• This is normal.
• Fit the water tank back onto the hou sing
correctly (you will hear a click).
• If the sound will not stop, do not use
the steam generator and contact an
authorised technical service centre.
• Use the steam release button at
intervals. This improves the ironing result
as the textiles will be steamed, dried and
ironed properly.
• Wipe the textile cover of the ironing
board, and iron any water drops to dry
them.
• Water drops stop coming out of the
soleplate after using the "PulseSteam"
function for some time.
• Place the hose on the opposite side so
that you cannot touch the hose during
ironing.
• Tighten up the boiler drainage plug with a
coin.
• Just press the trigger once again and the
iron will stop steaming at once.
21
B O SCH