Mounting Instructions - Klauke UAP4L Bedienungsanleitung

Instruction Manual
UAP4L
4.2 Explanation of the application range
The hand guided pressing tool serves to mount fi ttings
on multi Layer, copper and stainless steel type plumbing
pipes with Ø 12 to 54 mm, with pressing chain (page IV,
pic. 19) up to 110 mm dependant on the system. The unit
is not supposed to be restrained in a vise. It is not allo-
wed to use the tool in a stationary application. Complying
certain conditions the unit can be operated stationary with
our presentation support EKST-L. The conditions can be
taken from the instruction manual of the EKST-L.
The tool is not designed for continued pressing opera-
tions. After a sequence of approximately 50 completed
cycles you have to make a break of 15 minutes to give the
unit time to cool down.
Attention
Too intensive use can cause heat damages for
the tool
Attention
During the operation of built-in electric motors
sparks can occur which might ignite highly in-
fl ammable or explosive liquids and materials
Attention
Electric-hydraulic pressing tools must not be
operated in pouring rain or under water.

4.3 Mounting instructions

Please reference the assembly manual of the systems
supplier before mounting the fi ttings on the pipes. In order
to safeguard a proper pressing and to guaranty a safe
and reliable handling the machine must only be operated
with pressing jaws/~ chains recommended by the provi-
der of the pipe system and/or the tool manufacturer. If
the markings on the tool and pressing jaw do not match
respectively if there are no assembly instructions the user
has to contact the provider of the system to request a
compatibility statement.
Attention
Do not use bent or damaged pressing jaws.
For your job on the location we recommend the accesso-
ries shown on page VI in pic. 25.
Remark
As a system supplier/tool manufacturer we offer
perfectly designed pressing jaws for all known
systems and pipe dimensions. Special designs
and customer solutions upon request.
HE.13115_A © 09/2009
4.4 Service and maintenance instruction
The reliable performance of the tool is dependent on ca-
reful treatment and service. This represents an important
condition to safeguard a lasting connection. To safeguard
this the tool have to be maintained and serviced regular-
ly
We would like to draw your attention to the following
points:
1. The electric-hydraulic pressing unit have to be cleaned
and dried after each use before being put into the trans-
portation case.
2. In order to guaranty a proper function of the machine
the pressing tool should be returned to the manufac-
turer or one of our Authorized Service Centers (ASC)
after the light diode display indicates Service or after
each year whatever comes fi rst.
3. The battery as well as the charging unit must be protec-
ted against humidity and foreign objects.
4. The bolt joins, the rollers and their guides must be oiled
regularly in small amounts.
5. Check through test compressions or have the tool ma-
nufacturer check the tool and pressing jaws regularly
for proper function.
6. Keep pressing jaws clean. Remove dirt with a brush.
In order to avoid possible malfunctions we offer you a ma-
nufacturer service consisting of disassembly, cleaning,
exchange of possibly worn out parts assembly and fi nal
control (see ASC). Only a clean and properly functioning
press system can over the time safeguard a leaking free
connection.
Within the determined use of the tool only the pressing
jaws (page VI, pic. 25) are permitted to be changed by
the customers.
Attention
Do not damage the seals of the tool. If the seals
are damaged the warranty is invalidated.
3
GB