Remote Control Operation - Antari SW-250 Handbuch

REMOTE CONTROL OPERATION

ONLY FOR SW-250 MODEL
W-1: The wireless remote control W-1 consists of a transmitter equipped with two buttons for output on and off,
and a receiver pre-attached to SW-250.
* Transmitter
With the transmitter it is possible to output via radio over a distance of up to 50 meters. The transmitter is
compatible to any receiver of SW-250 and can control an unlimited number of machines in parallel. Press the
button "A", to ouput. As control, the LED on the transmitter is lit. To stop the output, press the button "B".
* Receiver
The receiver is tested and built in SW-250. Please do not try to remove it. The receiver responds to up to 5
different transmitters that are registered with the machine. The included transmitter has been registered with
the machine before shipment. It can be directly operated without any start-up setting.
Battery change on the transmitter
If the range of the transmitter decreases, the battery is probably exhausted and must be replaced. For this
purpose, take off the housing cover and remove the used battery. Insert a fresh 12 V battery, and refit the
housing cover.
SC-2 (Optional): 25 ft. wired ON/OFF and volume remote controller with 4 pin XLR plug.
7