Control Panel - IKEA HDN SW640 Betriebshandbuch

PRODUCT SHEET
5
1
3

1. Control panel.

2. Grease filter
3. Light
4. Steam deflector
5. Telescopic flue
Warning! The hood can support a maximum weight of 5 kg
Bulb maintenance
1. Disconnect the hood from the power supply.
2. Use a small screwdriver or another suitable tool to prise
and remove the lighting unit (Fig.1).
3. Replace the damaged lamp.
4. Only use 20 W max. - G4 halogen lamps, taking care not
to touch them with hands.
5. Close the lighting unit (snap-on).
Grease filters:
The metal grease filter has an unlimited life and must be
washed once a month by hand or in a dishwasher at a low
temperature and with short cycle. Washing in a dishwasher
can cause the grease filter to become opaque, but its filtering
capacity is not affected.
Grease filter maintenance:
1. Disconnect the hood from the power supply.
2. Remove the grease filter/s (Fig. 2). to remove it/them
pull the spring release handle backwards (f1) then remove
the filter/s downwards (f2)
Carbon filter maintenance
(for models with filter installation)
The carbon filter must be washed once a month in a
dishwasher at the highest temperature, using a normal
dishwasher detergent. It is advisable to wash the filters
separately.
After washing, reactivate the carbon filter by drying it in the
oven at 100° C for 10 minutes.
Change carbon filter every 3 years
Fitting the carbon filter:
1. Remove the grease filter (f1/f2 - Fig. 2).
2. Remove the filter holder by turning the knobs 90°
(g - Fig. 3).
3. Fit the carbon filter (i - Fig. 3) in the filter holder (h - Fig. 3).
Proceed in reverse order to refit the filter holder and grease
filter.
5019 618 33088/A
2
4
3
:
GB
D
CONTROL PANEL
Light button.
Press the button to switch on the lights.
Extraction speed selection button.
Press the button to select the power/speed.
Keep the button pressed for 2 seconds to go to OFF
status.
F I
f1
f2
Fig. 2
LI241A