Guarantee Cover
The equipment has been carefully pro-
duced in accordance with strict quality
guidelines and conscientiously checked
prior to delivery.
The guarantee applies for all material and
manufacturing defects. This guarantee
does not extend to cover product parts that
are subject to normal wear and may there-
fore be considered as wearing parts (e.g.
backflow stop, sealing ring) or to cover
damage to breakable parts (e.g. switches,
batteries, or parts made of glass).
This guarantee shall be invalid if the prod-
uct has been damaged, used incorrectly or
not maintained. Precise adherence to all of
the instructions specified in the operating
manual is required for proper use of the
product. Intended uses and actions against
which the operating manual advises or
warns must be categorically avoided.
The product is designed only for private
and not commercial use. The guarantee
will be invalidated in case of misuse or
improper handling, use of force, or inter-
ventions not undertaken by our authorised
service branch.
In the case of pumping water contain-
ing sand or aggressive liquids or other
incorrect, non-design-appropriate use, as
well as in case of non-observance of the
operating manual, application of force in
use or inappropriate or insufficient main-
tenance, no guarantee claim exists, since
seals, impeller wheel, motor or other parts
are damaged by this. Also, sewage water
pumps are not suitable for the pumping of
abrasive materials (sand, stone).
Note: submersible pumps are drainage
pumps. This kind of pump is constructed
with the purpose of transporting or remov-
ing a certain volume of water – depending
on its output category – as quickly as pos-
sible. Submersible pumps are not intended
as irrigation (for example, in garden ir-
rigation systems) or as constant water-flow
pumps (such as in artificial streams or or-
namental fountains). Inappropriate use will
invalidate the warranty.
Periodically check that the float switch is
operational. Warranty and liability claims
will be void in case on non-compliance or
if the pump runs dry.
In particular, the guarantee is likewise void
in the case of employment of the sewage
water pumps without base plate or (this
applies for all pumps) in case of damages
which are caused by supporting on or sus-
pending from the mains cable. The pumps
must not be run dry or exposed to frost.
Processing in Case of Guarantee
To ensure quick handling of you issue,
please follow the following directions:
•
Please have the receipt and identifica-
tion number (IAN 96809) ready as
proof of purchase for all enquiries.
•
Please find the item number on the rat-
ing plate.
•
Should functional errors or other de-
fects occur, please initially contact the
service department specified below by
telephone or by e-mail. You will then
receive further information on the pro-
cessing of your complaint.
•
After consultation with our customer
service, a product recorded as defec-
tive can be sent postage paid to the
service address communicated to you,
with the proof of purchase (receipt)
and specification of what constitutes
the defect and when it occurred. In or-
der to avoid acceptance problems and
additional costs, please be sure to use
GB
IE
CY
13