Maintenance And Care - Hotpoint Ariston MHR 940.1 (AN) /HA S Bedienungsanleitung

Maintenance and care

GB
Switching the appliance off
Disconnect your appliance from the electricity supply before carrying out
any work on it.
Cleaning the appliance
• The stainless steel or enamel-coated external parts and the rubber seals
may be cleaned using a sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for the removal of stubborn
stains. After cleaning, rinse and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The inside of the oven should ideally be cleaned after each use, while it is
still lukewarm. Use hot water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• All accessories - with the exception of the sliding racks - can be washed
like everyday crockery, and are even dishwasher safe.
! Never use steam cleaners or pressure cleaners on the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a sponge and a non-abrasive
cleaning product, then dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these could scratch the surface
and cause the glass to crack.
To clean more thoroughly, you can remove the oven door.
• Open the door fully and lift up the two small levers "B";
• Now, when the door is closed slightly, it can be lifted out by removing hooks
"A" as shown in figure.
To replace the door:
• With the door in an upright position, insert the 2 hooks "A" into the vents;
• Make sure that slot "D" is perfectly fastened to the edge of the vent (move
the door forwards and backwards slightly);
• Keep the door completely open, shift the 2 levers "B" downwards, then
close the door.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.
24
Replacing the light bulb
! Do not use the oven lamp as/for ambient lighting.
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: Wattage 25 W,
cap E 14.
3. Replace the glass cover (see
diagram).