Switching Via Step Keys; Switching Via A Serial Device; Connection Settings - G&D DL-MUX2-DP1.2-MC2 Bedienungsanleitung

Switching via step keys

Alternative to using select keys to switch between channels connected to the KVM
switch is to use the step keys to switch the channels in ascending or descending order.
IMPORTANT: The active step keys depend on the selected select keys. The following
table lists the step keys depending on the active select keys.
Select keys
1 ... 2
NUM 1 ... NUM 2
A ... B
F1 ... F2
How to use select keys to switch to a particular channel:
1. Press
Hotkey+»Forward« Step key

Switching via a serial device

The channels can be switched via a serial device connected to the RS232 interface of
the KVM switch. The serial device can either be a special keypad or a computer
which is terminal emulator operated.
IMPORTANT: Use the following connection settings and the switching commands of
the KVM switch to successfully switch the channel with a serial end device.

Connection settings

Use the following connection settings for the serial end device to establish a serial
connection to the KVM switch.
 Bits per second:
 Data bits:
 Parity:
 Stop bits:
 Flow control:
»Back« Step key
9
NUM 9
I
F9
or
Hotkey+»Back« Step key
9.600
8
none
1
none
Switching between the computers
»Forward« Step key
0
NUM 0
K
F10
on the console keyboard.
G&D DL-MUX2-DP1.2-MC2 · 9