Operation; Connecting The Compressed Air Supply; Filling The Blasting Medium Container - Parkside PDSP 1000 B2 Betriebsanleitung

■ Use only materials that are suited for use in the
GB
compressed air sandblaster gun
CY
use quartz sand. This can lead to a dangerous
build-up of silicosis-inducing dust.
■ Take steps to ensure that others are not incon-
venienced (dust formation).
■ Ensure that the blasting medium is collected so
that it can be disposed of in an environmentally
friendly manner.
■ Do not remove any type plates. These contain
important information for the safe operation of
the appliance.
■ If you are inexperienced with the appliance,
seek training in how to use it safely.
WARNING! TOXIC DUST!
► Working with harmful/toxic dusts results in
health hazards for the person operating the
appliance and for other persons in the area.

Operation

Connecting the compressed air supply

NOTE
► The compressed air sandblaster gun
only be operated on cleaned, condensate-
and oil-free compressed air and may not
exceed the maximum operating pressure of
6.3 bar at the appliance.
To ensure that you can regulate the air pres-
sure, the compressed air source should be
equipped with a (fi lter) pressure reducer.
♦ Connect the compressed air sandblaster gun
to a suitable compressed air source by attaching
the quick-connect coupling of the supply hose to
the nipple
The connection locks automatically.
NOTE
► Ensure that the control dial
before connecting the appliance to the com-
pressed air source.
4
. Do not
on the sandblaster gun
is set to "0"

Filling the blasting medium container

CAUTION!
► Before you open the screw cap
blasting medium container
other settings, the connection to the com-
pressed air hose must be disconnected and
all pressure completely discharged.
■ Use only suitable blasting medium
sandblasting work.
NOTE
► We recommend using a blasting medium
(ground blast furnace slag) with a grain size
of 0.2 mm–0.8 mm and which has been
shown not to cause silicosis.
■ Please ensure that the blasting medium
totally dry and not too coarse-grained.
NOTE
► The maximum grain size is 0.8 mm!
■ Open the screw cap
container
■ Fill the required amount of blasting medium
into the blasting medium container
may
■ Ensure that you do not exceed the maximum fi ll
level for the container of 900 ml.
■ Afterwards, close the screw cap
ing medium container
NOTE REGARDING THE GRAIN SIZE OF
THE BLASTING MEDIUM
► The larger/coarser the grain size of the blasting
medium used, the coarser the dirt that can be
removed using it. The supplied material, on
the other hand, is fi ne and thus more suitable
.
for the removal of items such as paint or rust
fi lm. The fi ne material also causes less dam-
age to the surfaces being treated, meaning a
choice can be made regarding these.
For coarse rust, for example, it is best to use
a coarse-grained blasting medium which you
can order online (see Chapter "Importer") or
in any good specialist retailer. Please observe
the guidelines regarding maximum grain size.
on the
, or make any
on the blasting medium
by turning it anti-clockwise.
on the blast-
by turning it clockwise.
PDSP 1000 B2
for your
is
.