Initial Operation; Fitting/Changing The Saw Blade; Fitting The Guide Fence; Connecting The Sawdust Extraction Appliance - Parkside PSTD 800 A1 Betriebsanleitung

Initial operation

Fitting/changing the saw blade

Always remove the plug from the power socket
before working on the appliance.
GB
♦ Flip up the pivoting guard
♦ Turn the quick-release chuck
this position.
♦ Press the required saw blade into the quick-
release chuck
♦ Release the quick-release chuck
return to its initial position. The saw blade is
now locked.

Fitting the guide fence

The guide fence
of the appliance.
♦ Undo both the clamping screws on the insertion
openings .
♦ Push the guide fence
ings .
♦ Retighten the two clamping screws.
Connecting the sawdust extraction
appliance
♦ Push the extraction connector
extraction duct until it is secured.
♦ Attach an approved dust and sawdust extractor
to the extraction connector

Fitting the sliding shoe

When working on sensitive surfaces, you can fi t
the sliding shoe
scratching the surface.
16
.
and hold it in
as far as the limit stop.
– it must
can be fi xed on the left or right
into the insertion open-
into the vacuum
.
on the baseplate to avoid
♦ Mount the sliding shoe
and press it up at the back until it clicks into
place on the baseplate
♦ To remove the sliding shoe
the rear of the baseplate
forwards.

Operation

Setting the cutting angle

♦ Undo the clamping screws
key and pull the baseplate
♦ Adjust the cutting angle to 0°/15°/30°/45°
with the aid of the markings on the baseplate
Push the baseplate
locking pin engages in the toothing
♦ Retighten the clamping screws
key .

Setting the stroke rate

♦ Use the stroke rate preselection adjusting
wheel to set the required stroke rate.

Setting the pendulum stroke

♦ You can use the pendulum stroke switch
the pendulum movement of the saw blade
You can achieve fi ne, clean cut edges without
pendulum movement (setting "0"). Switch the
pendulum movement off when working on thin
workpieces. You can achieve an increasingly
fast workrate with activated pendulum stroke
(settings 1–3).
Switching on/off
Switching the appliance on:
Press the ON/OFF switch
Switching the appliance off :
Release the ON/OFF switch
Switching to continuous operation:
Press the ON/OFF switch
position with the ON/OFF switch lock button
onto the baseplate
.
, unfasten it at
and slide it off
with the Allen
to the rear.
to the front so that the
.
with the Allen
to set
.
.
.
and lock it in this
.
PSTD 800 A1
.