Filling The Clean-Water Tank; Fill Level Indicator; Füllen Des Frischwassertanks; Füllstandsanzeige - Numatic TTV-5565 / 200T Bedienungsanleitung

1

Filling the clean-water tank

The TTV-5565 is equipped with a large capacity 85 litre clean-water tank allowing, for large areas to be covered in
a single fill.
To fill the clean-water tank, extend the hose located to the rear of the machine in the centre of the removable filler cap,
see (Fig.19). Pull out hose, (Fig.20). Open the stopper (Fig.21) and place hose under water tap, or use a hose to
commence filling, (Fig.22).
Or the tank can be filled by unscrewing the filler cap and using a bucket or similar container (Fig.23).
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris.
Fig.24
14
Fig.19
Fig.21
Fill-level indicator
The water level in the clean water
tank can be measured using the
scale on the rear of the machine
(fig.24).
The clean water bottom tank
holds 85 litres.
244033 06/13 (A07)
Fig.20
Fig.22 Fig.23
2