Power Supply Via Power Loop Cables - Guntermann & Drunck CompactCenter X2 Installationsanleitung

CATpro2-DVI-Audio

Power supply via Power Loop cables

If the optional AC adapter which is connected to the Power In interface is used to
supply the CATpro2-DVI-Audio target module with power, up to three further target
modules can be supplied with power via Power Loop cables.
1. Connect the AC adapter  to one of the target modules.
2. Insert a Power Loop cable  into the Power Loop interface of this target module.
Connect the other end to the Power In interface of the next target module.
3. If desired, repeat step 2 to establish the power supply to the third and fourth tar-
get module.
2 3
1
Def.
User
Learn
7
Trans. 1 Trans. 2 DDC
Figure 8: Power Loop power supply of four devices via one power pack
30 · G&D CompactCenter X2
« Target modules
2 3
1 4
Def. 5
User 6
Learn 7
Trans. 1 Trans. 2 DDC

4
5
6
Power Loop Power In
Trans. 1
2 3
1 4
Def. 5
User 6
Learn
7
Trans. 1 Trans. 2 DDC Power

Power Loop Power In
2 3
1 4
Def. 5
User 6
Learn 7
Trans. 2 DDC Power Loop

Loop Power In
Power In
