Guntermann & Drunck CATCenter Installationsanleitung Seite 76

Guntermann & Drunck GmbH
Use the Spacebar
•
Static
•
DHCP
•
Off
The two following entries are only available if you select the definition Static.
Note:
In the delivery state the IP-adress has the value 192.168.0.10.
Use the field Address to assign the static IP address of the CATCenter X8. To
do so, use the right arrow / left arrow
the four fields. Press the
field; the font color changes to yellow.
Enter the network mask in the Netmask field. To do so, use either the
arrow / left arrow
default is 255.255.255.0. Press the
individual field; the font color changes to yellow.
Establish the Ethernet connection speed and mode in the Connection field.
The following selections are available:
•
Manually establishing the Ethernet connection speed and mode
(100MBit full-duplex, 100MBit half-duplex, 10MBit full-duplex,
10MBit half-duplex)
•
Allowing the network interface and its communication partner (second
computer, hub, switch to negotiate the speed (Auto; default setting)
Note:
The communication behavior can be negatively influenced by the use of various
network components.
satisfactory results, depending on the manufacturer.
All editing tasks carried out up to this point are saved by pressing F2.
Press ESC to exit the menu without saving the changes you have made. If you
choose to do this, a warning message is displayed.
(toggle) to switch between the 3 entries:
ENTER key to activate edit mode in each individual
keys or the TAB
Thus the setting "Auto" does not always achieve
CATCenter Installation Guide
keys or the TAB
key to move to one of the four fields. The
ENTER key to activate edit mode in each
Page 28
key to move to one of
right