Connecting The Computers - Guntermann & Drunck DVIMUX4-PS/2 Installationsanleitung

Installation

Connecting the computers

IMPORTANT: KVM cable sets are required to connect the computers to the KVM
switch. All available KVM cable sets are listed on page 31.
Assign the cable sets to the different computers and have them available for instal-
lation.
NOTE: To connect the (maximum four) computers to the KVM switch, the inter-
faces as shown below are available for each computer.
The label (e.g. CPU 1
spondent button on the front panel.
Monitor 1
CON
Keyb. Mouse Speaker Line In
Figure 3: Interfaces to connect the computers
If the audio signals of the computers are to be output over the speakers which are
Line In:
connected to the KVM switch, use one of the audio connection cables (Audio-M/M) to
connect the computer's Line Out interface to this interface.
Use the purple plug of a Twin-PS/2 cable to connect the
Keyb.:
purple PS/2 socket (keyboard) to this interface.
Mouse: Use the green plug of a Twin-PS/2 cable to connect the
green PS/2 socket (mouse) of the computer to this interface.
If the computer is equipped with a DVI-D video output, use a digital
DVI-I CPU:
video cable (DVI-D-DL-M/M). If the computer has an analog VGA output, use an
analog video cable (VGA-M/DVI-A-M).
Connect the (first) video output of the computer to this interface.
NOTE: If you purchased a multi-channel variant of the KVM switch, connect the
DVI-I CPU x.2 (MC2, MC3 and MC4),
(MC4) interfaces to the correspending video output of the computer.
5 · G&D DVIMUX4-PS/2
) assigns the interface to a specific computer and to the corre-
DVI-I CPU 1.1 DVI-I CPU 2.1
CPU 1 CPU 2
Keyb. Mouse Line In Keyb.
DVI-I CPU 3.1
CPU 3
Mouse Line In Keyb. Mouse Line In
DVI-I CPU x.3 (MC3 and MC4) or
DVI-I CPU 4.1
CPU 4
Keyb. Mouse
DVI-I CPU x.4