Start Operation; Configuration - GREISINGER GMH 3181–13 Betriebsanleitung

H61.0.3X.6C-01

5 Start Operation

Connect sensor, turn on device via
After segment test
• If the logger function is not off the time of the integrated clock will shortly be displayed.
• If a zero point adjustment was carried out the display shows shortly „nuLL Corr".
After changing the battery
After that the device is ready for measuring.

6 Configuration

To change device settings, press Menu (key 4) for 2 seconds. This will call the configuration menu (main
display: „SEt").
Pressing key Menu changes between the menus, pressing (key 3) jumps to the referring parameters,
which can be selected with key (key 3).
The parameters can be changed with  (key 2) or  (key 5).
Pressing Menu again jumps back to the main configuration menu and saves the settings.
Quit (key 6) finishes the configuration and returns to standard measuring operation.
Please note: All here specified values are applying for all devices if there is no explicit mark.
The values for the different types of device can be checked up in chart (page 8)
Menu Param. Values
‚Menu'

SEt
Set Configuration: Generic Configurations
ConF
Unit mbar,bar..
SL oFF/on
Alti
-2000..9999
Slo
rAtE
FASt
P.dEt
1-120
t.AVG
oFF
1-120
P.oFF
oFF
oFF
Out
SEr
dAC
Adr. 01,11..91
dAC.0
p.r.t. chart
dAC.1
p.r.t. chart
SEt
Set Calibration: Adjustment of Sensor
CAL
p.r.t. chart
OFFS
oFF
-2.000 ...
2.000
SCAL
oFF
User's Manual GMH 3181-...
ON CAL
OFF max key.
1 2 3
Set min Store
Menu Quit
4 5 6
the device displays some configuration:
the clock-setting menu is activated automatically (‚CLOC'). Check the clock
and adjust, if necessary (p.r.t. chapter 6).
Description
 
or
Unit: Unit of display
Sea level correction: on or off
Altitude: Input of altitude above sea level [m] (only if SL=on)
Rate: Measuring rate (p.r.t. chapter 7.1)
Slow measuring rate (4Hz filtered, low power consumption)
Fast measuring rate, filtered (>1000Hz)
Peak detection: fast measuring rate, unfiltered (>1000Hz)
Averaging period in seconds, used by the averaging function
Averaging function deactivated
Auto Power Off time in minutes
Auto Power Off deactivated
Function of the output: No output function, lowest power consumption
Output is serial interface
Output is analogue output 0...1V
Base address of interface
Enter desired value at which the analogue output potential should be 0V
(if Out = dAC)
Enter desired value at which the analogue output potential should be 1V
(if Out = dAC)
The offset of sensor will be displaced by this value to compensate for
deviations in the probe or in the measuring device.
Zero displacement inactive (=0.00)
The measuring scale of sensor will be changed by this factor [%] to
compensate deviations of temperature probe or measuring device
Scale correction factor inactive (=0.000)
(only available at GMH 3181-12)
page 7 of 16
* *
* *
* *
* *
* *
* *
* *
* *
* *
*
*
*
*
*