WIKA CPH6000 Betriebsanleitung Seite 38
Der prozesskalibrator typ cph6000 vereint die vorteile eines kompakten hand-held-
instrumentes mit der umfangreichen funktionalität eines labor-kalibrierinstrumentes.
hierdurch gestalten sich alltägliche aufgaben im feld wie messen, prüfen oder kalibrie
Vorschau ausblenden
Andere Handbücher für CPH6000:
- Betriebsanleitung (112 Seiten) ,
- Betriebsanleitung (112 Seiten)
Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Commissioning, operation
7.2.3 Contents of the SETUP MENUS
GB
a)
MEASURING: Operating mode MEASURING
To measure working/process pressures
■
For comparative measurements and/or calibrations (without data recording) of mechani-
■
cal* and electrical pressure measuring instruments (supply and display of the test item
through the CPH6000)
For further information see chapters 7.3.1 "MEASURING mode" and 7.3.2 "MEASUR-
ING mode (with test item)"
b)
CALIBRATION: Operating mode CALIBRATION
For on-site calibration of mechanical* and electrical pressure measuring instruments
■
(without PC). In this case the data sets (for up to 16 test items, each with up to 32 test
points including date and time) are recorded within the CPH6000.
For further information see chapter 7.3.3 "CALIBRATION mode"
* For mechanical indicating instruments, the test item's measured value must be entered via the numeric keypad.
c)
SWITCH-TEST: Operating mode SWITCH-TEST
For the easy checking of pressure switches, including automatic calculation of the switch
■
hysteresis.
For further information see chapter 7.3.7 "SWITCH-TEST mode"
38
a
b
c
d
e
f
g
h
i
j
k
The calibration data can be transferred into printable certificates using
either PrintCal or EasyCal software.
WIKA operating instructions ProcessCalibrator, model CPH6000
Functions
CPH-Info
ReferenceSensor
Ref. Sensor-list
CPH-Configuration
Interface
CLEAR CalData
CPH switch off
Werbung
Kapitel
Inhaltsverzeichnis
