Herunterladen Inhalt Inhalt Diese Seite drucken

Technical Description; Rules For Installation - LA NORDICA FIREBALL Anweisungen

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Chimney stove FIREBALL

2. TECHNICAL DESCRIPTION

The chimney stoves of La Nordica are suitable to heat living spaces for some periods. As fuel, wood logs
are used. The stove is made of sheets in galvanized and painted steel, of cast iron (grate and grate holder
of the hearth, exhaust pipe) of majolica tiles and of glass panels. The hearth is totally sheathed with cast-
iron single sheets and refractory material (IRONKER). Inside there are a easy extractable thick flat grate
and its holder. The combustion chamber is hermetic welded and is sheathed with a painted steel carter.
The inside smoke plate made of vermiculite, reflects the fire radiation and increases the internal
temperature of the combustion chamber. This process together with the exhaust gases flows, makes
optimal the combustion and improves the efficiency.
Singular feature of the model "Carillon" is the pivoting body, i.e. the possibility of rotating the stove of +-
45° (with regard to its base axis) also when is lig hted. It is also possible to block the appliance at the
wished position by a knob. (Picture 1 pos.A)
The one-piece ceramic glass of the door (resistant up to 700 ° C) allows a wonderful view on the burnin g
flames. Furthermore, it is thus avoided the output of sparks and smoke.
Below the hearth grate there is an extractable ash drawer, (Picture 8 pos. A).
The heating of the environment is made by irradiation: through the panoramic glass and the external hot
surfaces of the stove, the heat is radiated into the environment.
The stove is equipped with controls of primary and secondary air by which it is adjusted the combustion air.
1 - Primary air register (left lever)
Below the hearth door, on the front left side, there is
the primary air register, in the style of lever (Picture
1 - 1)
With this air register, it is adjusted the passage of
primary air into the low part of the stove and through
particular channels flows in the fuel direction. The
primary air is necessary for the combustion process
during lighting. The ash drawer must be regularly
emptied, so that the ash does not obstruct the entry
of the primary air for the combustion.
In order to open the air flow, the bar must be
1
completely pulled out,
During wood combustion, the register of primary air
must be opened only for a while, because otherwise
A
the wood burns too fast and the stove may
overheat. For the coal combustion, the arrival of
primary air is absolutely necessary (see paragraph
2
10).
Picture 1
2 - Secondary air register (right lever)
Below the hearth door, on the right front side there is the
secondary air register (Picture 1 - 2).
The secondary air, passing through the two lateral jambs of the front side, heats itself starting the double
combustion and keeping at the same time the glass clean ( with open register).
When the bar is pushed to the back the passage of the secondary is completely open (Picture 1 - 2).

3. RULES FOR INSTALLATION

The stove, assembled and ready for the installation, must be connected with a junction to the existing flue
of the house. The junction must be possibly short, straight, horizontal or positioned a little uphill. The
connections must be tight.
20
Instructions for installation, use and maintenance – EN – Rev.04

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis