Technical Data; Proper Use - EINHELL BT-PG 2800/1 Originalbetriebsanleitung

equipment (this also applies to extension cables
and plug connections).
2. Layout (Fig. 1-5)
1 Tank indicator
2 Tank cover
3 2 x 230 V~ socket-outlets
4 Earth connection
5 Overload cut-out
6 Voltmeter
7 Oil filler plug
8 Oil drain plug
9 Oil shortage cut-out
10 On/Off switch
11 Choke lever
12 Reversing starter
13 Petrol cock
14 Wheels
15 Axle
16 Foot
17 Push bar holder
18 Push bar
19 Screws size M8 x 40
20 Screws size M8 x 16
21 Washers for wheels
22 Securing split pins for wheels
23 Nuts M8

3. Proper use

The device is designed for applications operated with
a 230 V alternating current source. Be sure to
observe the restrictions in the safety instructions.
The generator is intended to provide electric tools
and light sources with electricity.
When using the device with household appliances,
please check their suitability in accordance with the
relevant manufacturerʼs instructions. In case of
doubt, ask an authorized dealer of the respective
appliance.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Generator
Protection type:
Continuous rated power P
Maximum power P (S2 2 min):
max
Rated voltage U :
rated
Rated current I :
rated
Frequency F :
rated
Drive engine design:
Displacement:
Max. power:
Fuel:
Tank capacity:
Engine oil:
Consumption at 2/3 load:
Weight:
Sound pressure level L
Sound power level L
WA
Power factor cos ϕ:
Power class:
Max. temperature:
Max. altitude (above mean sea level):
Spark plug:
Operating mode S1 (continuous operation)
The machine can be continuously operated with the
quoted power output.
Operating mode S2 (temporary operation)
The machine may be temporarily operated with the
quoted power output. Afterwards the machine must
be stopped for a while to prevent it from overheating.
Synchronous
(S1):
rated
2 x 230V~
4-stroke, air-cooled
208 cm³
4.1 kW / 5.6 hp
approx. 0.6 l (15W40)
approx. 1.1 l/h
: 76 dB(A)
pA
/Uncertainty K:
96 dB (A)/1.4 dB(A)
GB
IP23 M
2300 W
2800 W
10 A
50 Hz
petrol
15 l
41.5 kg
1
G1
40°C
1000 m
F7 RTC
13