Fronius Selectiva 1006 Bedienungsanleitung Seite 26

Art. Nr.:
In:
Always stop charging before you disconnect the charging cable!
Toujours arrêter la charge avant de débrancher le câble de charge!
A
Art. Nr.:
In:
Always stop charging before you disconnect the charging cable!
Toujours arrêter la charge avant de débrancher le câble de charge!
IMPORTANT! It is not permitted to use this charger to charge dry batteries (primary cells).
Establishing con-
nection to bat-
tery/
disconnecting
Establish a connection as follows:
1
2
3
4
If using an on-board or system plug to connect the charger lead, steps 3 and 4 do not apply.
Instead, connect charger cable to a suitable on-board socket.
26
ACCTIVA EASY 1206
Chr. Nr.:
4,010,XXX,XXX 00000000000000
110-230V / 50-60Hz 48W Out: 12V = 2,5 - 4Aarith
B
00007432420000
SELECTIVA 1006
4,010,XXX,XXX Chr. Nr.: 00000000000000
110-230V / 50-60Hz 48W Out: 12V = 2,5 - 4Aarith
00007432420000
NOTE! Setting the selector switch incorrectly can result in the following:
- Charger displays incorrect test results
- Charger switches to "error"
- Battery will not be fully charged
- Vehicle power supply will be damaged (e.g. in back-up mode)
WARNING! Risk of explosion from short circuits and arcs. Before connecting/dis-
connecting the battery, disconnect the charger from the mains supply. During op-
eration, check that charging terminals and battery poles are properly connected.
Unplug the charger from the mains
Plug charger lead into charger socket
Connect (+) charging terminal to positive pole (red) on battery
Connect (-) charging terminal to negative pole (black) on the battery, or to vehicle body
(e.g. engine block) in the case of vehicle power supplies.
NOTE! When disconnecting, it is imperative to follow the above instructions in the
reverse order to avoid short circuits and arcs.
Acctiva Easy 1202, 1204, 1206, 2403
Charging characteristic setting:
Setting A: For charging all lead acid starter batteries
Setting B: Always charge using setting B for stationary batteries
in standby applications (e.g.: emergency power systems) or in
ambient temperatures exceeding 35 °C!
Selectiva 1006, 2003
Charging characteristic setting:
Setting A: For charging all lead acid traction batteries
Setting B: Always charge using setting B for stationary batteries
in standby applications (e.g.: emergency power systems) or in
ambient temperatures exceeding 35 °C!