General Description; Function Description; Summary; Assembly - Grizzly ERM 1846 G Originalbetriebsanleitung

General Description

Function Description

The electric lawnmower has a cutting tool,
which turns parallel to the cutting level.
It features a powerful electrical drive, a
sturdy metal casing, a safety switch, a
collision guard as well as a grass catcher
with level gauge. Additionally, the equip-
ment is height adjustable to seven levels
and has smooth-running wheels.
For the function of the operating parts,
please refer to the descriptions below.
The illustration how to handle the ap-
pliance can be found on page 2-4.

Summary

1 Curved handle
2 Start lever
3 Top star grip
4 Lower bar
5 Collision guard
6 Bottom star grip
7 Grass catcher
8 Back wheels
9 Front wheels
10 Housing
11 Cutting height adjuster
12 Cable holder
13 Cable strain relief
14 Connection cable
15 Release button (not visible)
16 Mains cable

Assembly

Disconnect the plug before any
work on the equipment. There is a
risk of injury.

Assembling the Curved Handle

Fitting the lower bar:

Position the ends of the bottom
bar (4) in the holding plates and
insert a screw into each from
the outside.
‚
Position the enclosed washers
and fit the bottom star grip (6).
Please note that the star grips
must be fitted inside.
ƒ
Screw the star grip (6) in place.
Install curved handle:

Use the enclosed screws to fix
the bow handle (1), with the
washers and top star grip (3) to
the right and left on the bottom
bar (4). There are two possible
positions.
‚
Turn the star grip (3) clockwise.
Screw the star grip (3) in place.
Clipping in the cable holder:
Clip the cable holder (
into the bottom bar and use it to
secure the equipment cable (
14).

Installing the grass catcher

Assemble the grass catcher:

Clip the rubber lip of the grass
catcher net (19) into the hard
plastic tray of the grass catcher
(7).
‚
Push the metal frame (20) into
the hard shell. Ensure that the
metal shell is pushed in fully.
ƒ
Pull plastic tabs (21) and (22)
over the metal frame (20).
„
Fix the metal frame (20) using
the enclosed screws.
GB
12)
23