Assembly And Operation - Worx Sonicrafter WX680 Originalbetriebsanleitung

High oscillation frequency.
Low oscillation frequency:
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your
local authorities or retailer for
recycling advice.
Oscillating Tool
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The power tool is intended for sawing and
remodelling wooden materials, plastic,
plaster, non-ferrous metals and fasteners (e.g.
nails and clamps) as well as for working on
soft wall tiles and for dry grinding of small
surfaces. It is especially suitable for working
close to edges and for flush cutting.

ASSEMBLY AND OPERATION

Action
Mounting accessories
Mounting the sanding
sheet
Mounting the suction
device (not supplied)
Operating the on/off
switch
Using the variable speed
dial
The Variable Speed Dial can be used to set
the optimum oscillating frequency according
to the accessories used and the respective
application.
Oscillation
Frequency
High oscillation
frequency
Low oscillation
frequency
Figure
See Fig. A-C
See Fig. D
See Fig. E1-E5
See Fig. F
See Fig.G
Application
Sanding, sawing,
rasping and
polishing stone and
metal.
Scraping, polishing
varnishes.
EN
9