Changing The Standard Plate - JVC kd-sc601 Bedienungsanleitung

2
While pressing DISP (display), press
and hold SEL (select) for more than
2 seconds.
Ex.: When you select CD as the source
3
Select a character.
A B C D
K L M N
U V W X
4 5 6 7
space
4
Move the cursor to the next
(or previous) character position.
5
Repeat steps 3 and 4 until you
finish entering the name.
6
Finish the procedure while the last
selected character is flashing.
To erase the input characters
To erase all the characters at a time, press and
hold DISP (display) for more than 1 second as
described in the procedure above.
E F G H I
O P Q R S
Y Z 0 1 2
8 9
– / <
Notes:
• When you try to assign a name to the 41st disc,
"NAME FULL" appears on the display. (In this
case, delete unwanted names before assignment.)
• When the CD changer is connected, you can assign
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs
in this unit.

Changing the standard plate

You can change the standard plate with another
plate supplied with your unit.
You can also download them by visiting
<http://www.jvc.co.jp/jvccar>.
• When changing the plate, be careful not to
leave your fingerprints on the plate or cover.
1
Loosen the screws with the supplied
hex screwdriver.
J
T
3
>
2
Remove the plate cover and the
standard plate.
Standard plate
CONTINUED ON THE NEXT PAGE
Plate cover
35