Finding the beginning of a
tune
Multi Music Scan (MMS) allows you to
automatically start playback from the beginning
of a specified tune. You can specify up to 9 tunes
ahead of or before the current tune.
During playback
Specify the tune you want to locate (how
many tunes ahead of or before the
current tune).
Press ¢
tune ahead of the current
tune on the cassette.
Press 4
tune before the current tune
on the cassette.
Ex.: When you locate three tunes ahead
of the current tune
Each time you press the buttons, the number
changes up to ±9.
When the beginning of the specified tune is
located, playback starts automatically.
Notes:
• While locating a specified tune:
– If the tape is rewound to its beginning, playback
starts from the beginning of that side.
– If the tape is fast-forwarded to the end, it is
reversed and played from the beginning of the
other side.
• In the following cases, the Multi Music Scan
function may not operate correctly:
– Tapes with tunes having long pianissimo
passages (very quiet parts) or non-recorded
portions between tunes.
– Tapes with short non-recorded sections.
– Tapes with high level of noise or humming
between tunes.
– Tapes with tunes recorded at low recording
levels.
Other convenient tape functions
Skipping the blank portions on the tape
You can skip blank portions between the tunes
(Blank Skip).
When this function is turned on, the unit fast-
forwards (skipping blank portions of 15 seconds
or more), to the next tune and starts playback.
• See also "Changing the general settings
(PSM)" on page 23.
1
Press and hold SEL (select) for more
than 2 seconds so that one of the
PSM items appears on the display.
to locate a
(PSM: see page 24.)
to locate a
2
Press ¢
"B.SKIP" (blank skip).
3
Turn the control dial clockwise to
select "ON."
4
Finish the setting.
To cancel Blank Skip, repeat the same procedure
and select "OFF" in step 3 by turning the control
dial counterclockwise.
or 4
to select
Now Blank Skip is
activated.
19