Finding The Beginning Of A Tune; Prohibiting Cassette Ejection - JVC KS-FX922R Bedienungsanleitung

To play back tapes recorded with the
Dolby B NR
Press and hold RPT (Dolby B/repeat) to set
the Dolby B NR* system.
The indicator lights up, and "DOLBY B"
appears on the display for several seconds.
To cancel the Dolby B NR, press and hold
RPT (Dolby B/repeat) again so that the
indicator goes off.
* Dolby noise reduction manufactured under
license from Dolby Laboratories Licensing
Corporation.
"DOLBY" and the double-D symbol
trademarks of Dolby Laboratories Licensing
Corporation.

Prohibiting cassette ejection

You can prohibit cassette ejection and "lock" a
cassette in the cassette compartment.
Press and hold TAPE 23 and
than 2 seconds.
"NO EJECT" flashes on the display for about 5
seconds, and the cassette is "locked."
To cancel the prohibition and "unlock" the
cassette, press and hold TAPE 23 and
for more than 2 seconds again.
"EJECT OK" flashes for about 5 seconds, and this
time the cassette is "unlocked."
Note:
If you press 0 while cassette ejection is prohibited,
the display panel flips down, but the cassette continues
to play and cannot be ejected.

Finding the beginning of a tune

Multi Music Scan allows you to automatically start
playback from the beginning of a specified tune.
You can specify up to 9 tunes ahead of or before
the current tune.
During playback
Specify how many tunes ahead of or
before the current tune the one you want
is located.
are
for more
Each time you press the buttons, the number
changes up to ±9.
When the beginning of the specified tune is
located, playback starts automatically.
Notes:
• While locating a specified tune:
– If the tape is rewound to its beginning, playback
starts from the beginning of that side.
– If the tape is fast-forwarded to the end, it is
reversed and played from the beginning of the
other side.
• In the following cases, the Multi Music Scan
function may not operate correctly:
– Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portions
between tunes.
– Tapes with short non-recorded sections.
– Tapes with high level of noise or humming
between tunes.
– The Dolby NR setting does not match. For
example, if Dolby B NR is on and the tape was
recorded with no Dolby NR.
Press ¢
to locate a tune
ahead of the current tune on the
cassette.
Press 4
to locate a tune
before the current tune on the
cassette.
17