Setting The Unit; Gain Control; Power Indicator; Cut Off Frequency Control - Pioneer prs x 340 Bedienungsanleitung

Setting the Unit

Gain Control

Adjusting the gain controls A and B will
help match the output of the car stereo
to the Pioneer amplifier. Normally, set
the gain controls to the "NORMAL"
position. If the output is low, even when
the volume of the car stereo is turned
up, turn these controls clockwise. If
there is distortion when the volume of
the car stereo is turned up, turn these
controls counter-clockwise.
• If you only use one input plug, set the gain
controls for speaker outputs A and B to the
same position.
• When using with an RCA equipped car
stereo (standard output of 500 mV), set to
the NORMAL position. When using with
an RCA equipped Pioneer car stereo with
max. output of 4 V or more, adjust level to
match the car stereo output level.

Cut Off Frequency Control

Combining LPF/HPF/BPF and
LOW/HIGH select switch settings lets
you select between cut off frequencies
from 40 to 120 Hz and 3k to 9k Hz.
(Example: LPF and HIGH)
(dB)
0
-3
Level
3
(3 kHz) (9 kHz)
Frequency (Hz)

Power Indicator

The power indicator lights when the
power is switched on.

BFC (Beat Frequency Control) Switch

If you hear a beat while listening to an
MW/LW broadcast with your car stereo,
change the BFC switch using a small
standard tip screwdriver.