Use - gourmetmaxx Z 05291 Classico Gebrauchsanleitung

Use

ATTENTION!
❐ Make sure that the rotary switch for setting the speed levels is in the 0 position be-
fore you connect the device to the mains.
❐ Do not switch on the device as long as the tilting mixer head is in an upright position.
❐ Never operate the device without food. This might result in the device overheating
or damage to the motor.
❐ Danger of injury due to rotating device parts! Keep body parts, hair, jewellery, and
clothing away from the device during use so that nothing can get caught in rotating
device parts.
❐ Caution – danger of scalding! Do not use any hot food in the device as it could spurt
out during use.
❐ Do not use any additional accessories. Only use accessories supplied by the manu-
facturer.
❐ Do not overfi ll the mixing bowl. This might result in the device overheating or dam-
age to the motor.
❐ The device is equipped with overload protection that deactivates the device when
it overloads. If this occurs, immediately disconnect the plug from the socket and let
the device cool off for approximately 10 minutes. Afterwards, the device is ready for
use again.
❐ Always assemble the device in full before you connect it to the mains power.
❐ Do not leave the device unattended during operation!
❐ During operation, keep children and animals away from the device in order to avoid
injury or damage to materials and the device itself!
❐ Remove the mains plug from the plug socket before each exchange of the inserts.
❐ Make sure that you do not use the inserts mixed up. Only either the dough hooks or
the stirrer inserts may be used at any one time.
1. Place the device on a dry, even and fi rm surface with suffi cient clearance around it.
2. Place the ingredients in the mixing bowl in accordance with your recipe.
3. Press the release button and attach the mixer head.
4. Insert the mixing bowl into the basic device. Rotate the mixing bowl clockwise to-
wards the closed lock symbol
you do so.
5. Choose the inserts you want (see the "Accessories" chapter).
6. Slide the inserts into the receiving socket on the mixer head. Note the markings (L
and R) on the inserts and the receiving socket. The insert with the marking R goes in
the receiving socket with the marking R. The same applies to the insert and receiv-
ing socket with the marking L.
7. Turn the insert to the right until the locking lug fi ts in the recess provided in the re-
ceiving socket. The insert must be heard to engage in place.
(on the basic device). Hold the turntable fi rmly as
17