Intenso S2500 Bedienungsanleitung Seite 15

2. Starting-Up / Powerbank Charge / Charging
Connected Devices
a) Charging the Powerbank
Please connect the included micro USB cable with the Powerbank micro USB
entry. Connect the other USB cable end with the standard USB port of a
computer or USB power supply. Charging process and actual charging status
are displayed by the status LED. If the Powerbank is completely charged, the
status LED lights up continuously. The needed charging of Powerbank
depends from the selection charging source and their starting performance
(5V / 1 A).
b) Charging devices through the Powerbank
 This Powerbank is equipped with an integrated USB cable plug (Standard
Output 1A).
 To charge a device by Powerbank, connect the micro USB connection of
the integrated cable with micro USB entry of the device to be charged.
The charging procedure starts automatically.
 If a device is charged with Powerbank and the Powerbank capacity has
almost finished, this is showed by red flashing of status LED. Please
recharge Powerbank.
 Please note that, when charging a device with a Powerbank nearly 30% of
total capacity is consumed by the charging process alone. This is caused
for example by the loss of power from circuit heat and voltage
conversion.
 For optimal performance, the Powerbank must be used regularly. If this is
not the case, fully charge the Powerbank at least every three months.
Page 6 of 8 EN