Extra Safety - Pelgrim IDK640 Anleitung

use
110
For the 2 zones left:
■ Press the + and - button of the zone front left during 3 seconds
In the displays of the zones left the following symbol appears
■
During a few seconds, after which the displays extinguish (in case of zones
non-operating), or after which the settings chosen will appear again (in case
of zones operating).
If you press one of the locked buttons, the symbol mentioned above will
appear during some seconds in the display of the cooking zone. The displays
extinguish (in case of zones non-operating), or the settings chosen will appear
again (in case of zones operating).
Unlocking
For the 2 zones right:
Press the + and - button of the zone front right during 3 seconds.
■
For the 2 zones left:
Press the + and - button of the zone front left during 3 seconds.
■

Extra safety

Safety hob
A sensor continuously measures the temperature of certain parts of the hob.
■
In case of temperatures rising too high, the power is reduced automatically.
■ As soon as you remove the pan from the hob, the cooking zone
automatically stops. Accustom yourself to stop the cooking zone or hob
manually to avoid unintended switching on of the induction hob.
Safety pans
Every cooking zone is equipped with a sensor that measures the temperature of
the bottom of the pan to avoid any risk of overheating when a pan boils dry.
111
.
use
Safety metal parts
A small part like a pan that is too little (smaller than 12 cm), a fork or a spoon is
not recognised as a pan by the induction hob. The display of the cooking
setting continues to flash and the zone will not switch on.
Overheatingprotection
The appliance may become overheated if:
■ the pan does not conduct the heat adequately;
fat or oil is heated at a high setting;
■
■ there is insufficient circulation of air (see also ventilation protection in the
installation part of this manual).
In the event of overheating the result will be that the cooking zone in question
or all the cooking zones will display one of the following reactions:
the hob will reduce the power supplied slightly (this is not visible in the
■
cooking settings in the displays);
■ if this does not help, the hob switch off and a series of dashes will appear in
the displays.
As soon as the cooking zone(s) has/have cooled down sufficiently, the dashes
disappear and the cooking zones remain switched off.
Prevent the overheating protection becoming activated by:
using pans that are good conductors of heat;
■
■ heating up fat or oil at a lower setting;
■ making sure there is sufficient ventilation.
If, despite the above-mentioned measures having been taken, the overheating
protection becomes activated again, contact the service department or a
professionally qualified specialist.