Change Of The Hinge Position - Pkm GS 108.4A++ Bedienungsanleitung

2. Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-
protection.
3. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
4. Check that the appliance and the power cord are not damaged.
5. Install the appliance in a dry and well-ventilated place.
6. Protect the appliance from direct sunlight.
7. The doors must open completely and without hindrance.
8. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
9. Connect the appliance to the mains properly.
10. The nameplate is inside the appliance or at the back.
Levelling
1. Use the adjustable feet at the front to level the appliance properly.
2. When the appliance is not levelled, the door and the magnetic seals will not
close properly.

Change of the hinge position

WARNING! Switch off and unplug the appliance before changing the hinge
position. RISK OF ELECTRIC SHOCK!
The change of the hinge position must be carried out by at least two persons;
otherwise you may hurt yourself or damage the appliance.
1. Remove the worktop by unscrewing the 2 screws on the back of the worktop.
Remove the worktop to the front and store it at a safe place to protect it from
damage.
2. Tilt the appliance slightly backwards and secure it in this position so it cannot
tip.
3. Unscrew the top hinge and lift the door from the hinge pin carefully. Store the
door at a safe place to protect it from damage.
4. Turn the top hinge by 180
5. Unscrew the bottom hinge.
6. Remove the screw-type foot and install it on the right side.
7. Fasten the bottom hinge loosely on the opposite side.
8. Put the door on the bottom hinge pin. Ensure that the hinge pin meets the hole
properly.
9. Fix the top hinge on the opposite side. Ensure that the hinge pin meets the hole
properly.
0
for later installation.
24