Troubleshooting; Safety Notices; Fault Indications - Caso MCG250 Pro Bedienungsanleitung

 Front of device and operating panel

Clean the front of the device and the operating panel with a soft, slightly damp cloth.

Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth
for cleaning.
► Leave the oven door open to prevent the device from being re-started accidentally.
 Exterior housing

Clean the exterior surfaces of the device with a damp cloth.
Rotating plate, baking sheet / pizza baking tray and rolling ring


The glass turntable and baking sheet / pizza baking tray must be removed and cleaned
occasionally. Wash the plate in a warm soapy solution or in the dishwasher.

The rolling ring should be cleaned regularly to prevent excessive noise development or
a rotational malfunctions.
The rolling ring can be washed in a mild soapy solution or in the dishwasher. Please
remember to put the rolling ring back again properly after cleaning it.

Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.

13 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

13.1 Safety notices

► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

13.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the
cause of the fault.
Error code
E01 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a cooking
chamber temperature of 300°C. Press the Stop button to acknowledge this
fault. The device can be re-activated after the cool down phase.
caso MCG250 Pro
Please note
Attention
Description
69