Blackout-Socket; Dmx-512 Connection / Connection Between Fixtures - Futurelight DJ-SCAN 1200 Bedienungsanleitung

Blackout-socket

If you wish to lock the light output - e.g. via an optional footswitch (Blackout-mode) or an Easy-2 remote
control, connect your footswitch or Easy-2 remote control via a mono-jack plug to the Blackout-socket.
Contact closure between tip and sleeve is reached when the footswitch is employed.

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
27/60 00028047.DOC, Version 1.1