L) Viewing Or Deleting Measured Data - Conrad 672861 Bedienungsanleitung

l) Viewing or Deleting Measured Data

View stored measured data/measured values:
• Touch the display area „MEMORY" in the lower right of the display once. The buttons „+" and „-" flash.
• You can use the two buttons „+" and „-" to display the measured values now.

The display shows the respective time and date of the measured value dataset.
In the basic setting, a dataset is stored every 30 minutes. This can be adjusted by PC software.
The display mode is left automatically if the touch screen is not touched for approx. 30 seconds.
Delete all stored measured data/measured values:
• Touch the display area „MEMORY" 2x.
The display area „MEMORY" flashes and the message „CLEAR" appears in the area of the data display at the
bottom.
• To delete all measured values that were saved, keep the display area „MEMORY" pushed for 3 seconds. The
memory display stops flashing; the data are deleted.
If you do not want to delete the data, either touch any other display area or wait for 30 seconds without touching the
touch screen.
88