Use; Cleaning The Interior; Use Of The Freezer - Starting; Temperature Regulation - Zanussi ZBB 6297 Bedienungsanleitung

USE

Control panel
A. Pilot light
B. SUPER operating control light
C. Warning light
D. Normal/Super (quick-freezing) switch
E. Thermostat knob

Cleaning the interior

Before using the appliance for the first time, wash
the interior and all internal accessories with luke-
warm water and some neutral soap so as to remove
the typical smell of a brand-new product, then dry
thoroughly.
Do not use detergents or abrasive
powders, as these will damage the finish.
USE OF THE FREEZER
This freezer compartment has been marked with
the symbol
suited to the freezing of fresh foods, the
conservation of frozen foods and the production
of ice-cubes.
Starting
Insert the power supply plug into the nearest wall
socket (the function indicator light (A) will light up
indicating that the freezer is receiving electrical
input). Turn the thermostat knob (E) to the right to a
medium setting (the temperature alarm light (C) will
light up). For the satisfactory conservation of frozen
foods, the freezer's internal temperature must be
lower than -18°C. Wait until the temperature alarm
light (C) turns off when the optimum temperature
has been reached.
To turn off the freezer, turn the thermostat knob to
I
the « » position. The refrigerator compartment will
remain operating.
S
A B C
, which means that it is
O
N
D E

Temperature regulation

The temperature is automatically regulated and can
be increased to achieve a higher temperature
(warmer) by rotating the thermostat knob toward
lower settings or reduced (colder) rotating the knob
towards higher settings.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
refrigerator depends on:
• room temperature;
• how often the door is opened;
• the quantity of food stored;
• location of appliance.
A medium setting is generally the most suitable.
Important
If the ambient temperature is high or the
appliance is fully loaded, and the appliance is
set to the lowest temperatures, it may run
continuously causing frost to form on the rear
wall. In this case the dial must be set to a higher
temperature to allow automatic defrosting and
therefore reduced energy consumption.

Quick-freezing

For quick-freezing, turn the N/S knob (D) to the «S»
symbol. The quick-freezlng indlcator light (B) will
then light up.
55