Assigning Names To The Sources - JVC KD-SH9101 Bedienungsanleitung

Assigning names to the sources

You can assign names to CDs (both in this unit
and in the CD changer), and the external
component.
After assigning a name, it will appears on the
display when you select the source.
Sources
CDs* Up to 32 characters (up to
40 discs)
External component Up to 8 characters
* You cannot assign a name to CD Text, MP3, and
WMA discs.
.
1
Select a source you want to assign a
name to.
When you select a source, the
SRC
power automatically comes on.
2
While holding DISP (D), press and
hold SEL (select) for more than
2 seconds.
D
DISP
Ex.: When you select CD as the source
Maximum number of
characters
SEL
3
Select the character set you want
while the first character position is
flashing.
Each time you press the button,
D
the character set changes as
follows:
DISP
A – Z
(Upper case) (Lower case)
Accented letters
(Lower case)
4
Select a character.
ATT
5
Move the cursor to the next
(or previous) character position.
6
Repeat steps 3 to 5 until you finish
entering the name.
7
Finish the procedure while the last
selected character is flashing.
SEL
To erase the entered characters
Insert spaces using the same procedure
described above.
Notes:
• When you try to assign a name to the 41st disc,
"Name Full" appears on the display, and you
cannot enter the text entry mode. In this case, delete
unwanted names before assignment.
• When the CD changer is connected, you can assign
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs
in this unit.
a – z 0 – 9 & symbols
(Numbers)
Accented letters
(Upper case)
• About the available
characters, see page
71.
51