Troubleshooting; Assistance - Hotpoint Ariston EBYH 18343 F D Gebrauchsanleitung

Troubleshooting

If the appliance does not work, before calling for Assistance
(see Assistance), check for a solution from the following list.
The display is completely switched off.
• The plug has not been inserted into the electrical socket, or
not far enough to make contact, or there is no power in the
house.
• The I-Care function is active.
The motor does not start.
• The appliance comes with a motor protection control (see
Start-up and use).
The display is on but it is dim.
• Pull out and reverse the plug before putting it back in the
socket.
The alarm sounds and DOOR OPEN ALARM flashes on the
display (ìdrî is displayed instead of the REFRIGERATOR
temperature).
• The refrigerator door has been open for more than two
minutes.
The sound alert stops when the door is closed or when the
appliance is switched off and on again.
The alarm sounds and TEMPERATURE ALARM flashes
on the display (ìA1î is displayed instead of the FREEZER
temperature).
• The temperature inside the freezer is too high. The freezer
will maintain a temperature of around 0°C so that the food
will not refreeze, allowing you to eat it within 24 hours or to
refreeze it after it has been cooked.
To switch off the buzzer, open and close the appliance door
or press the + and – freezer temperature adjustment buttons
once. Press these buttons a second time to display the set
value on the freezer display, switch off the TEMPERATURE
ALARM LED and restore normal operation.
The alarm sounds and temperature alarm flashes on
the display (ìA2î is displayed instead of the FREEZER
temperature).
• The temperature of the freezer is dangerously high: the
food inside must not be eaten. The freezer will maintain a
temperature of approximately -18°C.
To switch off the buzzer, open and close the appliance door
or press the + and – freezer temperature adjustment buttons
once. Press these buttons a second time to display the set
value on the freezer display, switch off the TEMPERATURE
ALARM LED and restore normal operation.
The refrigerator and the freezer do not cool well.
• The doors do not close properly or the seals are damaged.
• The doors are opened too frequently.
• The temperature that has been set is too high (see Start-up
and use).
• The refrigerator or the freezer have been over-filled.
The food inside the refrigerator is beginning to freeze.
• The temperature that has been set is too low (see Start-up
and use).
The motor runs continuously.
• The function SUPER FREEZE has been enabled
• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high.
The appliance makes a lot of noise.
• The appliance has not been installed on a level surface (see
Installation).
• The appliance has been installed between cabinets that
vibrate and make noise.
• The internal refrigerant makes a slight noise even when the
compressor is off. This is not a defect, it is normal.
Early ending of functions
• Electrical disturbance on the network or brief interruptions of
the power supply.
GB
27