Specifications - Roadstar HIF-1899TUMPK Bedienungsanleitung

ENCODING OF CD/PHONO INTO MP3 FILE
The system is able to ENCODE normal CD, CASSETTE or TURNTABLE to MP3 format and
recording at memory media with USB connecting port.
A) CD ENCODING
I) Ecnoding 1 track
1. perform normal playback of the cd track you want to encode & record,
2. press " RECORD " button (9) twice during the playback of the desire track, unit will
display. Encoding is performing now.
4. Press the STOP button to finish recording the track.
II) Encoding 1 disc
1. Place a cd with the printed side facing up inside the tray & then close the co door
2. press the " RECORD " button (9) twice after focus search completed. unit will display
" " . Encoding is performing now.
3. After completing of encoding, unit will stop playback automatically.
REMARK:
- The recording speed is 1:1 and according to the actual plying time of the cd track
- The system will creat a " RECORD " folder and then store the encoding track in it.
- The recording format is preset at – MP3
- No song title will be recorded during encoding mode
- To interrupt the recroding, press the " RECORD " button again during record mode.
- Recording will be completed only entire song being encoded, if terminate the
encoding process intermediately, there is no track being recorded nor stored to
the USB.
III) COPYING OF MP3/WMA FILE
If putting a MP3/WMA disc instead of a CD-DISC, the system will copy the files to the USB
or SD card if press the " RECORD " button (9). The operation procedures is same as cd
encoding as stipulate on above, and the system will switch to copying mode only if MP3/
WMA file being read.
English
bit rate : 128 kbps, sampling rate : 44.1khz
English
9 10
B) PHONO ENCODING
1) Insert the USB device.
2) Press the function button to " PHONO ".
3) Start playback at PHONO for the track which you want to record to USB.
4) Press the RECORD button two times to start encoding.
5) The display show REC.
4) After finish of recoding, press the STOP button to stop recording.
C) CASSETTE ENCODING
1) Insert the USB device.
2) Press the function button to "TAPE ".
3) Start playback at TAPE for the track which you want to record to USB.
4) Press the RECORD button two times to start encoding.
5) The display show REC.
4) After finish of recoding, press the STOP button to stop recording.
REMOVING OF USB / MEMORY CARD
To remove the USB, turn off the power or switch the function mode to either CD, AUX or
TUNER first. Un-plug it by pulling out the USB socket directly.
DELETE TRACKS FROM USB
1) Insert the USB device.
2) Press the function button to "CD/USB ".
3) Press the button FUNCTION to select USB device.
4) During playback or STOP condition, press the button DELETE from Remote Control
to delete the current track.

SPECIFICATIONS

Power Supply
AC:
RC Battery:
Radio Frequency Coverage
FM:
MW:
Design and specifications are subject to change without notice.
230V ~ 50Hz
CR-2025
87.5 - 108MHz
522 - 1620kHz