AEG SANTO K 7 10 03-6 i Gebrauchs- Und Einbauanweisung Seite 28

From the plastic cover (E), which is
used to cover the hinge with the
pivot pin, you must take away the
part as indicated in the drawing.
This operation is made easer since
there is, in the internal part of the
cover hinge lid a groove that facila-
tes the removal of this coomponent..
"Remove the part marked with DX, if
the pivot pin is inserted in the right
hinge, SX in opposite case."
Apply covers (C-D) on joint cover
lugs and into hinge holes.
Snap vent grille (B) and hinge
covers (E) into position.
Separate parts Ha, Hb, Hc, Hd as
shown in the figure
Place guide (Ha) on the inside part of
the furniture door, up and down as
shown in the figure and mark the
position of external holes. After
having drilled holes, fix the guide
with the screws supplied.
28
C
D
E
Ha
Hb
Hc
Hd
PR266
ca. 50 mm
ca. 50 mm
E
B
90°
90°