Eizo Flex Scan S1721 Installationshandbuch Seite 10

Prior to use
No-Picture Problem
If no picture is displayed on the monitor even after the following remedial action is taken, contact your local dealer.
1. Check the Power indicator.
Symptom
No picture
* For detail of the gain adjustment, please refer to the User's Manual on the CD-ROM.
2. Check the error message on the screen.
These messages appear when the input signal is incorrect even if the monitor is functioning.
Symptom
8
Installation Setting/Adjustment
Status
Power indicator does not light
up.
Power indicator lights blue.
Power indicator lights orange.
Status
The input signal is not received
correctly.
The signal frequency is outside
the specifi cation. Incorrect
signal frequency is shown in
red.
Troubleshooting
Possible cause and remedy
Check whether the power cord is correctly
connected. If the problem persists, turn off the
monitor for a few minutes, and then turn it on
again.
Press again.
Check the gain* setting.
Operate your mouse or keyboard of the PC.
Possible cause and remedy
Check whether the PC is turned on.
Check whether the signal cable is properly
connected to the PC.
Change the mode to an appropriate mode using
the graphics board's utility software. Refer to the
manual of the graphics board for details.