Futurelight DMH-40 Bedienungsanleitung Seite 45

- Main menu 4
• Press [ENTER] to enter the main menu (display flashing).
• Press [UP] to select "EDIT".
- Define the number of steps in Run
With this function you can define the number of steps in the Program Run.
• Select "STEP" by pressing [UP] or [DN].
• Press [ENTER], the display shows"S-XX", "X" stands for the total amount of steps you want to save, so
you can call up to 48 scenes in "RUN". For example if the "XX" is 05, it means that "RUN" will run the first 5
scenes you saved in "EDIT".
• Press [ENTER] to save and exit.
"TIME".
• Press [ENTER] to edit the time needed, the display shows "TXXX", "XXX" stands for the time needed to run
the current scene, value "001-999". For example, "T002" means you need 0.4 ms (002 x 0.2 ms) to run the
current scene.
• Adjust the desired time by pressing [UP] or [DN].
• Press [ENTER] to save the settings for the scene you are editing, the display will change to the next scene
automatically.
• Repeat above steps to edit and other scenes, you can edit and save a maximum of 48 scenes.
• Press [MODE/ESC] to exit. The number of steps can be defined under "STEP" and the scenes can be
called up under "RUN"
b) Editing via the external controller
• Call up the first scene in your controller now.
• Select "SC01" by pressing [UP] or [DN].
• Press [ENTER], the display shows "SC01".
- Auto scenes rec
With this function you can automatically record new scenes.
• Select "REC" by pressing [UP] or [DN].
• Press [ENTER], the display shows"RE-XX", "X" stands for the
total amount of memorizable scenes, you can call up in "RUN".
For example if the "XX" is 05, it means that "RUN" will run the
first 5 scenes you saved in "EDIT".
• Press [ENTER] to save and exit.
- Editing the channels of the individual scenes
With this function you can edit the program to be called up in
Run.
a) Editing via the Control Board
• Select "SC01" by pressing [UP] or [DN].
• Press [ENTER], the display shows "SCXX", "X" stands for the
scene no. to be edited.
• Change the scene no. by pressing [UP] or [DN].
• Press [ENTER], the display shows "C-XX", "XX" stands for
the channel no. Such as "C-01", it means you are editing
channel 1 of the selected scene.
• Select the channel no. you would like to edit by pressing [UP].
• Press [ENTER] to enter editing for the selected channel , the
fixture reacts to your settings. The display shows the DMX value
of the edited channel. Such as " 11XX", it stands for channel 11
of the current scene, the DMX value is XX , XX is a
hexadecimal number value "01-FF".
• Adjust the desired DMX value by pressing [UP] or [DN].
• Press [ENTER] in order to edit other channels of this scene.
• Repeat above steps until you finish setting all the DMX values
for all channels of this scene.
• Once all the channels completed, the display will flash
45/48 00056440.DOC, Version 1.0