Memory; Saving Memory Settings; Starting The Memory; Changing The Signal Duration - CONSTRUCTA CN161152 Gebrauchsanleitung

Memory

You can save the settings for a dish in the memory and call it
up again at any time.
The memory is useful for if you frequently prepare a specific
dish.

Saving memory settings

Example: 360 W, 25 minutes
Press the l button.
1.
The indicator light above the button lights up.
Press the required microwave power setting.
2.
The indicator light above the button lights up and 1:00 min
appears in the display.
Set the cooking time using the rotary selector.
3.
Confirm by pressing the l button.
4.
The clock reappears. The setting is saved.

Changing the signal duration

You will hear an audible signal when the appliance is switched
off. You can change the duration of the signal.
To do so, press the ƒ button for approx. 6 seconds.

Care and cleaning

With careful care and cleaning your microwave oven will retain
its looks and remain good order. We will explain here how you
should care for and clean your appliance correctly.
:
Risk of short circuit!
Never use high-pressure cleaners or steam cleaners to clean
the oven.
:
Risk of burns!
Never clean the appliance immediately after switching off. Let
the appliance cool down.
:
Risk of electric shock!
Do not immerse the appliance in water or clean under a jet of
water.
20
Notes
You can save the memory settings and start the appliance
■
immediately. When finishing, instead of pressing l, press ƒ.
You cannot save several microwave power settings one after
■
the other.
You cannot save automatic programmes.
■
Saving a new setting in the memory: press the l button.
■
The old settings appear. Save the new programme as
described in steps 1 to 4.

Starting the memory

It is very easy to start the saved programme. Place your meal
into the appliance. Close the appliance door.
Press the l button.
1.
The saved settings are displayed.
Press the ƒ button.
2.
The cooking time counts down in the display.
The cooking time has elapsed
An audible signal sounds. Open the appliance door or press
„. The clock reappears.
Pausing
Press the „ button once or open the appliance door.
Operation is suspended. The display above the ƒ button
flashes. After closing the door, press the ƒ button again.
Cancelling operation
Press the „ button twice or open the door and press the „
button once.
The new signal duration is adopted.
The clock reappears.
The following are possible:
Short signal duration - 3 tones
Long signal duration - 30 tones.
Surfaces are different, and damage caused by using the wrong
cleaning agent can be avoided by observing the information in
the table below.
Do not use
sharp or abrasive cleaning agents.
■
The surface could be damaged. If such a substance comes
into contact with the front of the appliance, wash it off
immediately with water.
metal or glass scrapers to clean the glass in the appliance
■
door.
metal or glass scrapers for cleaning the seal.
■
hard scouring pads or cleaning sponges.
■
Wash new sponge cloths thoroughly before use.
cleaning agents with high concentrations of alcohol.
■