General Power Tool Safety Warnings; Work Area Safety; Electrical Safety - Parkside PSBSA 18-Li A1 Originalbetriebsanleitung

Noise and vibration data:
Noise measurement value determined in accordance
with EN ISO 4871 The A-rated noise level of the
power tool is typically:
Sound pressure level:
Sound power level:
Uncertainty K:
Vibration values (vector total of three directions)
determined in accordance with EN 60745
Screws: Vibration emission value
a
h
Uncertainty K = 1.5 m/s
Drilling in metal: Vibration emission value
a
h,D
Uncertainty K = 1.5 m/s
Hammer drilling
in concrete: Vibration emission value
a
h,ID
Uncertainty K = 1.5 m/s
Wear ear protection!
NOTE
► The vibration level specifi ed in these instruc-
tions has been measured in accordance
with the standardised measuring procedure
specifi ed in EN 60745 and can be used to
make equipment comparisons. The specifi ed
vibration emission value can also be used to
make an initial exposure estimate.
PSBSA 18-Li A1
85 dB(A)
96 dB(A)
3 dB
2.5 m/s 2
2
= 5.4 m/s 2
2
= 11.1 m/s 2
2
WARNING!
► The vibration level varies in accordance with
the use of the power tool and may be higher
than the value specifi ed in these instructions
in some cases. There is a risk of underestima-
tion of the vibration load if the power tool is
used regularly in this manner. Try to keep the
vibration loads as low as possible. Measures
to reduce the vibration load are, e.g. wearing
gloves and limiting the working time. Wherein
all states of operation must be included (e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
General Power Tool
Safety Warnings
WARNING!
► Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fi re and/or serious
injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit. Cluttered
or dark areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence of fl am-
mable liquids, gases or dust. Power tools create
sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.

2. Electrical safety

a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodifi ed plugs and matching outlets
will reduce risk of electric shock.
GB
IE
3