Rc Functions; Trim; Landing; Maintenance - XciteRC Flybar 180S Coast Guard Bedienungsanleitung

RC functions

EN

Landing:

• Carefully push the left throttle lever rearward. Try to land „smooth" without damaging the helicopter.
• NOTE: if the flight battery runs empty, the helicopter does not respond accurately to your com-
mands, the flight is unstable. In this case land immediately.
• Switch of the helicopter and then the transmitter.
WARNING: the motor of the XciteRC FLYBAR 180S may get very hot during operation. Allow to cool
down minimum 20 minutes before the next start to avoid damage. Fire hazard!

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
18
Up - down
Move the throttle lever forward, the motor revs up and the he-
licopter rises. Move the throttle lever backwards to sink again.
Left - Right
Move the direction lever to the left, the helicopter turns to the left.
Move it to the right to turn the helicopter to the right.
Forward - reverse
Move the direction lever towards you, the helicopter will move
forward. Move the throttle stick back to reverse.

Trim

Yaw: Watch the helicopter at the start. If the nose turns - just
before take-off - to the left or right, this can be corrected with the
trim for yaw (see Fig.) If it turns to the left, press the trim lever to
the right until the nose stops moving. If it turns to the right, press
the trim lever to the left.
RC functions · Landing
XciteRC Flybar 180S Coax