Herunterladen Inhalt Inhalt Diese Seite drucken

Preparation; Things To Be Done For Energy Saving; Initial Use - Grundig GTM 14130 Bedienungsanleitung

Kühlschrank/ gefrierschrank
Vorschau ausblenden Andere Handbücher für GTM 14130:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

4

Preparation

4.1 Things to be done for
energy saving
A
Connecting the product to electric
energy saving systems is risky as it may
cause damage on the product.
• Do not leave the doors of your refrigerator
open for a long time.
• Do not put hot food or drinks in your
refrigerator.
• Do not overload the refrigerator. Cooling
capacity will fall when the air circulation
inside is hindered.
• Do not place the refrigerator in places
subject to direct sunlight. Install the
product at least 30 cm away from heat
sources such as hobs, ovens, heater cores
and stoves and at least 5 cm away from
electrical ovens.
• Pay attention to store your food in
refrigerator in closed containers.
• You can load maximum amount of food to
the freezer compartment of the refrigerator
by removing the freezer compartment
drawers. Declared energy consumption
value of the refrigerator was determined
with the freezer compartment drawers
removed,except if available bottom drawer
and with maximum amount of food loaded.
There is no risk in using a shelf or drawer
suitable for the shapes and sizes of the
foods to be frozen.
• Thawing frozen food in fridge
compartment will both provide energy
saving and preserve the food quality.
C
The ambient temperature of the room
where you install the refrigerator should
at least be -15°C. Operating your
refrigerator under colder conditions
than this is not recommended.
Refrigerator /User Manual
C
Inside of your refrigerator must be
cleaned thoroughly.
C
If two coolers are to be installed side
by side, there should be at least 4 cm
distance between them.

4.2 Initial use

Before starting to use the product, check that
all preparations are made in accordance
with the instructions in sections "Important
instructions for safety and environment" and
"Installation".
• Clean the interior of the refrigerator as
recommended in the "Maintenance and
cleaning" section. Check that inside of it is
dry before operating it.
• Plug the refrigerator into the grounded
wall outlet. When the door is opened the
interior illumination will turn on.
• Run the refrigerator without putting any
food for 6 hours and do not open its door
unless certainly required.
C
You will hear a noise when the
compressor starts up. The liquids and
gases sealed within the refrigeration
system may also give rise to noise, even
if the compressor is not running and this
is quite normal.
C
Front edges of the refrigerator may
feel warm. This is normal. These areas
are designed to be warm to avoid
condensation.
C
For energy efficiency, it is
recommmended to remove top shelf
and load food on the shelf below.Net
volume of your appliance is declared
without top two flaps and the top
shelf in place.Place two ice pack ( if
provided ) directly on the top of frozen
food to be stored on top shelf.
15 / 20 EN

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Gtm 14120

Inhaltsverzeichnis