Bosch PSR 7,2 LI Originalbetriebsanleitung Seite 22

OBJ_BUCH-781-004.book Page 22 Tuesday, September 6, 2011 3:13 PM
22 | English
Service
Have your power tool serviced by a qualified repair person using
only identical replacement parts. This will ensure that the safety of
the power tool is maintained.
Safety Warnings for Screwdriver
Hold power tool by insulated gripping surfaces, when performing
an operation where the fastener may contact hidden wiring. Fas-
teners contacting a "live" wire may make exposed metal parts of the
power tool "live" and could give the operator an electric shock.
Hold the machine with a firm grip. High reaction torque can briefly
occur while driving in and loosening screws.
Always wait until the machine has come to a complete stop before
placing it down. The tool insert can jam and lead to loss of control over
the power tool.
Before any work on the machine (e. g., maintenance, tool change,
etc.) as well as during transport and storage, set the rotational di-
rection switch to the centre position. Unintentional actuation of the
On/Off switch can lead to injuries.
Protect the power tool against heat, e. g., against continu-
ous intense sunlight, fire, water, and moisture. Danger of
explosion.
In case of damage and improper use of the battery, vapours may be
emitted. Provide for fresh air and seek medical help in case of
complaints. The vapours can irritate the respiratory system.
Safety Warnings for battery chargers
Keep the battery charger away from rain or moisture. Pen-
etration of water in the battery charger increases the risk of an
electric shock.
Only charge Bosch lithium ion batteries or batteries installed in
Bosch products with the voltages listed in the technical data. Oth-
erwise there is danger of fire and explosion.
Keep the battery charger clean. Contamination can lead to danger of
an electric shock.
Before each use, check the battery charger, cable and plug. If dam-
age is detected, do not use the battery charger. Never open the
2 609 005 644 | (6.9.11) Bosch Power Tools