Slave Mode; Dmx Mode - EuroLite LED PMC-16x30WCOB RGB Bedienungsanleitung

Auto Mode
In Auto Mode, the chasers are called up automatically in a continuous loop.
Press the MODE button to select the AUTO mode.
Press the ENTER button to select the desired frequency of the loops.
The desired frequency of the loops (Frequency = FQN 01-99) can be selected via the UP or DOWN buttons.
Please press the ENTER button to confirm.
Sound Control Mode
Press the MODE button and choose Sound Controlled Mode (SOUND).
Press the ENTER button to select the desired sensitivity and frequency of the loops, respectively.
The desired sensitivity (SENS 00-31) can be selected via the UP or DOWN buttons.
Please press the ENTER button again to confirm.

Slave Mode

Press the MODE button to select the SLAVE Mode. The devices set in this manner can now be controlled by
the master unit.
Please press the ENTER button to confirm.

DMX MODE

The device has four DMX channel modes. The Control Board allows you, as described below, to assign the
DMX channel mode.
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED PMC-16x30W COB RGB will respond to the controller.
You can control the devices individually via your DMX-controller. Every DMX channel has a different
occupation with different features.
Please, be sure that you don't have any overlapping channels in order to control each LED PMC-16x30W
COB RGB correctly and independently from any other fixture on the DMX chain. If several LED PMC-
16x30W COB RGB are addressed similarly, they will work synchronically.
Addressing
Press the MODE button until the display shows DMX MODE.
Press the ENTER button and the display shows: 001.
Set the desired address via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to select a DMX Channel Mode.
Controlling:
After having addressed the LED PMC-16x30W COB RGB, you may now start operating it via your lighting
controller.
Note: It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order
to ensure proper transmission on the DMX data link.
Choosing a DMX Channel Mode
After having set the desired addresses and pressed ENTER, you can now choose a DMX channel mode
(3 CH, 5 CH, 48 CH or 51CH).
Set the desired mode via the UP or DOWN buttons.
Press the ENTER button again to confirm.
Please see the following DMX protocol graphic for the respective channel values.
24/27 00069590.DOC, Version 1.0