Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
13. SWITCH-OFF
13.1.
WOOD SWITCH-OFF
By interrupting the feeding of wood, the stove goes out naturally.
To light the stove again, follow the indications given in the chapter 9.1.
13.2.
PELLET SWITCH-OFF
The stove is supplied with a system that interrupts pellet supply to the burner ( B ):
Using the WOOD-PELLET switch-over lever in the "L-W-H" position(Picture 8 pos.C) it is possible to block the natural
sliding of the pellet into the burner.
In this way it is possible to "switch the stove off", which will continue its functioning once the pellets have finished,
which is under the switch-over lever.
To light the stove again, follow the indications given in the chapter 9.2.
14. MAINTENANCE AND CARE
Maintenance operations guarantee correct functioning of the product through time. Failure to comply with these
operations can jeopardise the safety of the product.
Have your local chimney sweep check the regular installation of the stove, the connection to the chimney and
aeration.
To clean the enamelled parts, use soapy water or detergents that are NON-ABRASIVE or NOT chemically
aggressive.
IMPORTANT: only use spare parts expressly authorised and offered by NORDICA S.p.A. If necessary, please
contact your specialised dealer.
THE APPLIANCE CANNOT BE MODIFIED!
14.1.
FLUE CLEANING
The correct lighting procedure, the use of quantity and type of suitable fuels, the sufficient draught of the chimney and
the presence of combustion air are indispensable for excellent appliance functioning. It is recommended to clean the
appliance completely at least once a year , or when necessary (malfunctioning or little yield). This operation must only
be performed when the stove is cold, it should be performed by a chimney sweep, who may make an inspection at the
same time.
The ash drawer and the combustion gas pipe must be removed from the stove during cleaning.
The combustion gas collection chamber can be cleaned from the hearth and, after having removed the combustion
gas pipe, also from the exhaust stub pipe with the aid of a brush and suction device.
ATTENTION: after cleaning, all parts removed must be re-installed correctly in their original position.
14.2.
CLEANING THE GLASS
The formation of dirt deposits on the glass is effectively reduced by means of a specific secondary air inlet. However,
it can never be prevented with the use of solid fuels (e.g. wet wood) and this must not be considered as an appliance
defect.
IMPORTANT: The panoramic glass must only be cleaned when the stove is cold to prevent explosion. DO
NOT use cloths, abrasive or chemically aggressive products.
The correct lighting procedure, the use of quantity and type of suitable fuels, the sufficient draught of the chimney and
the presence of combustion air are indispensable for excellent appliance functioning and to keep the glass clean.
BREAKING THE WINDOWS: As the windows are in ceramic glass, resistant up to a temperature change of
750° C, they are not subject to heat shocks. They ca n only be broken by
mechanical shocks (blows or violent closure of the door etc.). Therefore
replacement is not covered by the warranty.
14.3.
CLEANING THE ASH DRAWER
All LA NORDICA products have a drawer for collecting ash (Picture 12 pos.A).
It is recommended to empty the ash drawer periodically and to avoid its
complete filling, so as not to over-heat the burner ( B ).
IMPORTANT: do not empty the ash drawer when the stove is functioning
in Pellet mode.
ATTENTION: the ashes removed from the hearth must be placed in a fire-proof
30
CLEO COMBI.
A
Picture 12
8192000 Rev.08 – EN
Werbung
Inhaltsverzeichnis
