Throttle Range Explanation - Carson FY5 Destroyerline Brushless Betriebsanleitung

j. Throttle Range Explanation
Forward
zone
Top point/
maximal throttle
Alert tones
• Alert tone input voltage abnormal:
The ESC begins to check the input voltage when power on. If it is
out of the normal range, such an alert tone will be emitted:
"beep-beep-, beep-beep-, beep-beep-" (There is 1 second time
interval between every "beep-beep-" tones).
• Alert tone throttle signal abnormal:
When the ESC can't detect the normal throttle signal, such an alert
tone will be emitted:
"beep-, beep-, beep-" (There is 2 seconds time interval between
every "beep-" tones).
Reset all items to default values
At any time when the throttle is located in neutral zone (except in the
throttle calibration process or ESC program mode), you can hold the
"SET" key for over 3 seconds. The red LED and green LED will flash at
the same time, which means each programmable item has be reset to
its default value.
Top point/
maximum brake
Brake and
backward zone
Neutral point
CARSON FY5 Destroyerline Brushless 50 040 9040
LED status of normal running
• In normal use, if the throttle stick is in the neutral range, neither the
red LED nor the green LED lights.
• The red LED lights when the car is running forward or backward and
it will flash quickly when the car is braking.
• The green LED lights when the throttle stick is moved to the top
point (end point) of the forward zone or backward zone.
Protection function
1. Low voltage cut-off protection: If the voltage of a lithium battery
pack is lower than the threshold for 2 seconds, the ESC will cut of
the output power. Please note, that the ESC cannot be restarted if
the voltage of one lithium cell is lower than 3.5 V.
2. Over-heat protection: When the temperature of the ESC is over a
factory preset threshold for 5 seconds, the ESC will cut off the
output power. When the over-heat protection happens, the green
LED will flash in such a style: "✼, ✼, ✼" (single flash).
3. Signal loss protection: The ESC will cut off the output power if the
throttle signal is lost for 0.2 second.
GB
27