Futurelight PLB-15R Bedienungsanleitung Seite 55

• Press the Enter-button.
• Press Up or Down to select the desired sensitivity.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Hibernation - power standby mode
With this function you can put the device in the power standby mode. This function will be automatically
activated after a predefined period of time of no DMX activity. In standby mode the lamp/LEDs and all motors
will power down if no DMX signal is sent to the fixture for a period of e. g. 15 minutes (can be user defined).
The fixture will automatically reset and return to normal operation once a DMX signal is sendet.
Service setting
The password for this function is „050".
RDM
With this function you can call up various submenus via RDM.
This device is RDM ready. RDM stands for "Remote Device Management" and makes remote control of
devices connected to the DMX-bus possible. ANSI E1.20-2006 by ESTA specifies the RDM standard as an
extension of the DMX512 protocol.
Manual settings like adjusting the DMX starting address are no longer needed. This is especially useful when
the device is installed in a remote area.
RDM is integrated n the DMX-protocol without influencing the connections. The RDM-data is transmitted via
the standard XLR-poles 1 and 2 – new DMX-cables are not necessary. RDM ready and conventional DMX
devices can be operated in one DMX line. The RDM protocol sends own packages in the DMX512 data feed
and does not influence conventional devices.
If DMX splitters are used and RDM control is to be used, these splitters must support RDM.
The number and type of RDM parameters depend on the (optional) RDM controller being used.
In general, the device supports the following commands and functions via RDM:

DMX-Address

Lamp on/off

PAN reverse

TILT reverse

Reset default

Display reverse

Reset all

User mode

Lamp hours

Head temperature

Software version
Adjust ventilation fans mode
With this function, you can adjust the ventilation fans mode.
• Select "Fans Control" by pressing Up or Down.
• Press Enter to confirm; the display shows "AUTO".
• Press Up or Down to select "LOW", "HIGH" or "AUTO".
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Display shutt off time
With this function you can shut off the display after 1 to 59 minutes.
Display reverse
With this function you can flip the display by 180° for a better view when the fixture is hung from the truss or
a ceiling.
55/60 00072726, Version 1.0