Futurelight PLB-15R Bedienungsanleitung Seite 43

Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Install the safety bond by inserting the quick link in the hole on the bottom of the base. Pull the safety bond
over the trussing system etc. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!
(1) Omega-holders
(2) Clamp
(3) Safety-rope
(4) Quick-lock fastener
Screw one clamp each via a M10 screw and nut onto the Omega-clamps.
Insert the quick-lock fasteners of the first Omega-clamp into the respective holes on the
bottom of the device. Tighten the quick-lock fasteners fully clockwise. Install the second
Omega-clamp.
DANGER TO LIFE!
43/60 00072726, Version 1.0