Making Connections - Sony MEX-XB100BT Bedienungsanleitung

*1 Not supplied
*2 Speaker impedance: 4 – 8 Ω × 4
*3 RCA pin cord (not supplied)
*4 Depending on the type of car, use an adaptor for a
wired remote control (not supplied).
For details on using the wired remote control, see
"Using the wired remote control" (page 31).
*5 Whether in use or not, route the microphone input
cord such that it does not interfere with driving
operations. Secure the cord with a clamp, etc., if it is
installed around your feet.
*6 For details on installing the microphone, see
"Installing the microphone" (page 31).
*7 Depending on the type of car, use an adaptor (not
supplied) if the antenna connector does not fit.
*8 Use speakers with 50W RMS or higher power input
capacity. Using Sony XB series full range speakers is
recommended.
*9 When the amperage rating of the fuse used on your
car is 10 A, make the power connection to the
battery directly to avoid short circuits.

Making connections

If you have a power antenna (aerial) without a relay
box, connecting this unit with the supplied power
supply lead  may damage the antenna (aerial).
 To the car's speaker connector
1
Rear speaker
(right)
2
3
Front speaker
(right)
4
5
Front speaker
(left)
6
7
Rear speaker
(left)
8
 To the car's power connector
continuous power
12
supply
power antenna (aerial) /
13 power amplifier control
(REM OUT)
30
GB

Purple
Purple/black

striped

Gray

Gray/black striped

White
White/black

striped

Green
Green/black

striped
Yellow
Blue/white striped
switched illumination
14
power supply
15 switched power supply
16 ground (earth)
When connecting to the battery directly
When the amperage rating of the fuse used on your
car is 10 A, make the power connection to the
battery directly to avoid short circuits.
 to a metal point of car
 to the positive battery terminal
Notes
 Despite connecting to the power supply lead of the
car, the unit may not fully provide its performance
due to insufficient power. In this case, make the
power connection to the battery directly.
 All power wires connected to the positive battery post
should be fused within 450 mm (18 in) of the battery
post, and before they pass through any metal.
 Make sure that the car's battery wires connected to
the car (ground (earth) to chassis)* are of a wire
gauge at least equal to that of the main power wire
connected from the battery to the head unit.
 During full-power operation, a current of more than
15 A will run through the system. Therefore, make
sure that the wires to be connected to the +12 V and
GND terminals of this unit are at least 14-Gauge
(AWG14) or have a sectional area of more than 2mm²
( 3 / in).
32
Less than 450 mm (18 in)
Fuse (15 A)
If you have any questions or problems concerning
the connection, consult the dealer for details.
Subwoofer Easy Connection
You can use a subwoofer without a power amplifier
when it is connected to a rear speaker cord.
Notes
 Preparation of the rear speaker cords is required.
 Use a subwoofer with an impedance of 4 to 8 ohms,
and with adequate power handling capacities to
avoid damage.
Memory hold connection
When the yellow power supply lead is connected,
power will always be supplied to the memory
circuit even when the ignition switch is turned off.
Orange/white
striped
Red
Black
*
+12 V car battery
Front speaker
Subwoofer