Connector Assignment; Installation Bmw 3Series E90 - Dietz IMU 1563 Bedienungsanleitung

Connector assignment

cable
red
black
green
3 pin connector

Installation BMW 3series E90

1. Switch off ignition and remove the key.
2. Remove and disconnect the head unit (double DIN device with
2 CD slots).
3. Release the fibre optic cables from the main MOST
small connector (pic.2). Afterwards push out the blue locking (pic.3), and then pull out the fibre optic from
the output (!) (see the right arrow on pic.4), while carefully bending the clip with a small screw driver. Then
put this fibre optic into the connector from the enclosed fibre optic cable kit (pic.5, this connector must lead
to the input of IMU 1563 on its' other end via the fibre optic!!) The remaining fibre optic without connector
now has to be plugged into the open slot (pic.6). With that, the fibre optic ring must be closed entirely again!
4. Re-connect the small fibre optics connector with the MOST
5. Connect the remaining fibre optics connector (pic.7) with the counterpart at the IMU
pic.2, terminal E).
6. Now connect the black and green wire from the harness plugged into terminal D (page 12, pic2.) with
ground, the red one with "permanent" +12V.
I/O
Input
Input
Input
Output
Copyright © by Audiotechnik Dietz
Rev. 3 Stand: 06 / 2010
marking
Power +12 V, KL. 30
ground
ground
Remote
®
connector of the head unit (pic.1), and pull out the
®
main connector
®
Vertriebs-GmbH ● Germany
13
®
1563 (see page 12,
E
N
G
L
I
S
H